Physics static and rotational equilibrium lab

Balancing Act

Robins' original work used a heavy iron pendulum, faced with wood, to catch the bullet. GPE of weight, length and position of arms; why do these affect range?

The angle that the wires make with the horizontal is varied from 60 degrees to 15 degrees. Journal of Food Processing and Engineering The hand belongs to Mia. The picture is in a state of equilibrium, and thus all the forces acting upon the picture must be balanced.

That worked but it didn't get very hot so I shortened the wire from 1 m 10 ohms to about 20 cm and that made it about 2 ohms and about 70W on a 12 V supply. Thrust is generated by the rocket's motor.

Once the components are known, they can be compared to see if the vertical forces are balanced and if the horizontal forces are balanced. However, as the air in the headspace expands, the pressure decreases and you would think the rate of flow gets less.

The sheet thickness can be measured with a micrometer. Even if your device is not a weapon under the Act your teacher may consider it too dangerous for a school activity. This is similar situation to a baseball bat, a kitchen knife and so on which are also not weapons unless used for a behavioural offence.

The problem for you is how to display and analyse the data. When Physics static and rotational equilibrium lab charge it you will need a resistor to ensure the current doesn't go over 3.

Here's my setup and graph. There are lots of things that would make a great EEI.

Equilibrium and Statics

You will have to get parental supervision if you are using power tools or testing it at home. In this photo, students are using layers 1, 2, 3 etc of shade cloth. Because the change in resistance is not large you need to choose your meters and scales with care.

If you have a voltmeter that has a full scale deflection FSD of 1V then the wire should give a current of about 40mA. This might explain why the model fails at low speeds. For my eighty [Year 12] students a good number will do the resistance EEI I use two microohmmeters for two weeks.

Assuming that the sign is at equilibrium a good assumption if it is remaining at restthe two cables must supply enough upward force to balance the downward force of gravity.

It is all a balance of wire length and voltage so that the readings are close to FSD. The sling and the arm swing up to the vertical position, where usually assisted by a hook, one end of the sling releases, propelling the projectile towards the target with great force.

A small "spud" potato gun may or may not be a firearm depending on whether it can cause a bruise. As another example that illustrates this idea, consider the symmetrical hanging of a sign as shown at the right.

Year 12 student Ryan Phillips from Villanova College, Brisbane, used an Physics static and rotational equilibrium lab bar heater in front of the solar panel. I've seen these cups made from the plastic PVC caps they use for plumbing see below.

An analysis of the horizontal components shows that the leftward component of A nearly balances the rightward component of B. Stephen used a balance with a precision of 0. When these two junctions are kept at different temperatures a small voltage occurs. When finished, click the button to view the answers.

Then I tried wrapping a part of the rod with a plastic oven bag polyester and then wrapping a coil of nichrome wire from a jug element around it and connecting it to a 12 V DC supply.

Do this by setting up the circuit on the left below, using either a variable resistor or fixed resistors that can be varied from 0 ohm to ohm.

If so, you could put a load on the circuit resistor and measure V and I. I measured the output of each IC by connecting them in turn to an Arduino with a simple temperature reading 'sketch'. The vector sum of all the forces is nearly equal to 0 Newton.

When the applied force is enough to balance the meter stick and mass static equilibriumstudents record the force applied by the force sensor, the distance from the pivot to the force sensor, and the distance from the pivot to the mass. In an EEI you would have to look at resistivity, temperature coefficients of resistance and why - at an atomic level - resistance changes.Torques in Equiibrium Lab by Tom Blum.

PYL Rotational Equilibrium. It is easier to open a heavy door when you know where the hinges are. Then you know to apply your force at the opposite end of the door. (rotation). Thus no net torque is another condition for static equilibrium.

Part 1. Set up a lever-type system. Recall the following. Then, we must also place it in a state of rotational equilibrium where the sum of all of the torques equals zero. For horizontal beams in the plane of the page, the torques will either result in a clockwise (cw) rotation or a counterclockwise (ccw) rotation.

Apply what you know about torques by making a mobile. Shown below are five horizontal arms with fixed 1- and 2-kg masses attached, and four hangers with ends. Then, we must also place it in a state of rotational equilibrium where the sum of all of the torques equals zero.

For horizontal beams in the plane of the page, the torques will either result in a clockwise (cw) rotation or a counterclockwise (ccw) rotation. Rotational Statics Lab Summary. Students use a force sensor and tension protractor to demonstrate that the sum of the forces acting on an object in static translational equilibrium is equal to zero, and the sum of the torques acting on an object in static rotational equilibrium is equal to zero.

The perfect physics book, thank you! This is exactly what I wanted. Along with guiding readers through the fundamental concepts, formulas and their derivation, the text provides historical details about the development of physics as a field, which I really appreciate.

Download
Physics static and rotational equilibrium lab
Rated 4/5 based on 53 review